New product - News Releases A leading manufacturer of valves, pumps and manifolds ― Takasago Electric, Inc.

Welcome to Takasago Electric, Inc., a leading manufacturer of valves, pumps and manifolds

High-Temperature High-Pressure Valve

Up to 180°C & 800 kPa

Features

・Employs a unique mechanism to absorb the dimensional changes of the plastic body caused by temperature changes. No leakage with high temperature fluids.

・Most suitable for the case sulfuric acid is heated for COD Measurement.

・An elastomer is employed for the seal material, reducing damage to the valve seat by foreign matters in the fluid and associated leakage problem.

October 31, 201112:00 AM | comment(0) | TrackBack(0)

Chemically Inert Moulded Body Solenoid Valve PKV Series

Moulded 3-way PKV series valve now available

Features

φ4-6mm is its orifice diameter, which enables it to be used in a wide-range of fluid control applications for various kinds of analysis, IVD diagnostics, medical, and other life science instruments, etc., which necessitate such large orifice. An elastomer is employed for the seal material, reducing damage to the valve seat by foreign matters in the fluid and the associated leak trouble.

June 9, 201112:00 AM | comment(0) | TrackBack(0)

Proportional Diaphragm Valve -NPV Series-

Features

· Has a very high chemical resistance due to all PTFE wetted parts.

· Flow controllable by changing the input voltage.

· Has a comparatively large orifice diameter of 4mm, which can cover a wide range of flows

April 27, 201112:00 AM | comment(0) | TrackBack(0)

Pen-Type Glass Syringe Pump

Features

· Remarkably small outer dimensions of Dia. 8.8 x L 121 mm, now with a built-in stepper motor (with a reduction gear).

· With a lightweight of only 33 g, this pump is very suitable for installation on the stage of a microscope, inside an incubator, or on moving parts, etc.

· Continuous microlitre transfer system can also be made possible by operating 2 pieces of syringe pumps alternately.

· Theoretical resolution is 21 nl.

· Has a built-in sensor that enables zero-point detection.

· In addition to the needle model in the above picture, a No.6-40UNF threaded port model and a special attachment model to connect with our small 3-way valve are also available.

· A driver for operating this pump has also been prepared.

February 8, 201112:00 AM | comment(0) | TrackBack(0)

Highly Inert Models APP Series

Uses only PEEK and Perfluoroelastomer as wetted materials.

Most suitable for aggressive chemicals, solvents, etc.

Features

· Small-sized, lightweight and slim.

· Typical flow is 15 ml/min, which is adjustable by changing drive voltage or drive frequency.

· Low noise and low power consumption.

· PPS or FPM is optionally available as wetted materials.

· Self-priming is possible.

February 8, 201112:00 AM | comment(0) | TrackBack(0)

Solenoid-driven Slider Valve

Pumping volume has a negative effect on analysis accuracy and precise fluid dispensation. Through the incorporation of part of the flow path into a sliding structure, this pumping volume is reduced to almost zero and an impressive increase in operating pressure is exhibited. In addition, the elimination of excess internal volume reduces cross-contamination. Amongst many varied possible applications, this valve can be utilized as a sample injector.

December 7, 200911:12 AM | comment(0) | TrackBack(0)